﻿Extension types and attributes (New extensions, currently only available for the arched and standard hangars)

Extension types:
L - Extensions to the left of the hangar.
R - Extensions to the right of the hangar.
B - Extensions to the back of the hangar.

All extension types need at least a size value and there is an optional offset value. All values are in centimetres. Example B(400) creates a 4 metre long extension at the back, and B(400x150) creates a 4 metre long extension 1.5 metres from the hangar back wall.

Extension attributes:

C - Extension side offset. Different syntaxes: C(<front/left offset>), C(<front/left offset>x<back/right offset>), C(<front/left offset at hangar wall end>x<front/left offset at extension end wall>;<back/right offset at hangar wall end>x<back/right offset at extension end wall>), C(<front/left offset>;<back/right offset at hangar wall end>x<back/right offset at extension end wall>), C(<front/left offset at hangar wall end>x<front/left offset at extension end wall>;<back/right offset>),

H - Extension height, if not set, this will be the height of the hangar. Different syntaxes: H(<height>) and (<height>x<height repeated>x<height gap>). The last syntax is for walls only and is used to create fences
A - Arc height. If not set the arc height will be set to 0. Different syntaxes: A(<arc height>), A(<arc height>x<arc height middle of extension>), A(<arc height>x<arc height middle of extension>x<arc type>), A(<arc height>x<arc height middle of extension>x<arc type>x<arc direction>), A(<arc height>x<arc height middle of extension>xx<arc direction>). Notice the xx in the last syntax. Arc types are N (or leave blank as in the last example) for Normal and H, HW and HP for hipped roof. Arc directions are W (or leave out) for the middle arc running along the width of the extension, and L for the middle arc running along the length of the extension.

P - Posts, this is for walls and roof only. Different syntaxes: P(<posts>) and P(<posts>x<post offset>).

F - Floor, this is for walls and roof only. Different syntaxes: F(<floor height>) and F(<floor height>;<floor type>). Floor types are W for wooden planks and C for concrete. If floor type hasn't been selected, wooden planks are selected as default. The attribute is used as a height offset for walls only.

G - Gates, this is for walls only used in conjunction with posts. This is to select which wall panels to be excluded. Syntax: G(<panel number>). Panel numbers (from right to left, or back to front) are between 0 and number of posts minus one.
N - Rotation, this is will rotate the extension clockwise around a set rotation point. Syntax N(<angle>x<rotation x coordinate>x<rotation y coordinate>)

T - Texture, this will allow you to set a custom texture to a part of the extension. Syntax T(<texture type>;<texture name>). Texture types are W for walls and R for roof.

R - Draw roof only
W - Draw walls only
NP - No posts, draw wall panels only. 


