One Click Hangar > Support
AFCADs for P3D v4?
Jorgen:
Quick question: I saw oin the readme on one of the AFCADs that it was for FSX and P3D. Is that valid for all of them, and does that include P3D v4?
Thanks -
Jorgen
charlymorton:
Hi Jorgen,
This may have been made before P3D v4 was released. All AFCADs are made for FSX and should work fine in P3D v1-3. Not sure about v4.
Jorgen:
So maybe I should try out a couple in P3D v4. Would there be one that's more likely to cause issues than the others, or are they all the same in that respect?
Jorgen
Jorgen:
Well, I downloaded the Falklands AFCADS and tried a couple, and all worked well, except that Pebble Island is out in the Ocean by itself... maybe we could call it off-shore!
But no crashes or anything. I will experiment with a couple more and report back.
This is on a system with an Intel i7-7700K, running at its native 4.2 GHz, with 16 GB of 2133 MHz DDR4 RAM and a nVidia GTX 960 graphics card
Jorgen
Jorgen:
I just tried a couple of Tanzanian airports, no problems there either.
Jorgen
Navigation
[0] Message Index
[#] Next page
Go to full version