Messages

81

Alberta / Re: Syncrude C-FSNC Citation II

« on: January 16, 2021, 10:12:40 AM »

Oh, the paints are OK and installed, no problem there.

The aircraft are not in any flight plans, is the issue. The Skywest plans are from OCH, the Turbo Air plans are from  Eric Steinmetz.

Jorgen

82

Alberta / Re: Syncrude C-FSNC Citation II

« on: January 16, 2021, 09:28:08 AM »

John,

I am (slowly) working my way through all the repaints, and up until now I have found two others that are not in flight plans. They are:

Turbo Air Beech C90 N900AC
Skywest Air Services Cessna 182 C-GWGF

The Turbo Air Summer 2020 and Skywest Air Services Summer 2020 plans are installed....

Jorgen

83

Alberta / Re: Syncrude C-FSNC Citation II

« on: January 15, 2021, 03:37:02 PM »

Ah thanks, that took care of that!

Jorgen

84

Alberta / Re: Syncrude C-FSNC Citation II

« on: January 15, 2021, 10:20:32 AM »

John,

It looks like this birdie is not in any of my flight plans, and I believe I have all the most recent plans from here.... is there something I am not seeing?

Thanks for all your paints, I am installing away!

Jorgen

Edit: C-FYMM that you refer to doesn't seem to have any flight plan either....

85

Support / Re: AFCADs for P3D v4?

« on: August 31, 2018, 07:21:48 AM »

Sounds good, I'm looking forward to that.

Jorgen

86

Support / Re: AFCADs for P3D v4?

« on: August 30, 2018, 04:23:20 PM »

I just tried a couple of Tanzanian airports, no problems there either.

Jorgen

87

Support / Re: AFCADs for P3D v4?

« on: August 30, 2018, 02:38:38 PM »

Well, I downloaded the Falklands AFCADS and tried a couple, and all worked well, except that Pebble Island is out in the Ocean by itself... maybe we could call it off-shore!

But no crashes or anything. I will experiment with a couple more and report back.

This is on a system with an Intel i7-7700K, running at its native 4.2 GHz, with 16 GB of 2133 MHz DDR4 RAM and a nVidia GTX 960 graphics card

Jorgen

88

Support / Re: AFCADs for P3D v4?

« on: August 29, 2018, 02:48:46 PM »

So maybe I should try out a couple in P3D v4. Would there be one that's more likely to cause issues than the others, or are they all the same in that respect?

Jorgen

89

Support / AFCADs for P3D v4?

« on: August 27, 2018, 10:29:33 AM »

Quick question: I saw oin the readme on one of the AFCADs that it was for FSX and P3D. Is that valid for all of them, and does that include P3D v4?

Thanks -

Jorgen